0
The diameter of today's horizontal axis wind turbines are up to 125m in diameter. This can produce up to 8MW of power.
What else can I help you with?
What is the width of a wind turbine?
The diameter of today's horizontal axis wind turbines are up to 125m in diameter. This can produce up to 8MW of power.
What is HP and LP turbine expansion?
HP Turbine is High Performance Turbine LP Turbine is Low Performance Turbine
Would a turbine be a chemical or physical change?
Turbine is not a change, a turbine is a mechanical device.
What is difference between radial flow turbine and axial flow turbine?
in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.
How do you spell turbine?
Turbine is the correct spelling.
How long and how thick are wind turbine blades?
Wind turbines blades are about 15 meters long (average wind turbine) The thickness of the blade depends on the length of the blade. The width is about 10% of the length, in this case, would be about 1.5 meters thick.
Gas turbine generator?
gas turbine generator
What is mix pressure turbine?
mix-pressure turbine
What is the wheel chamber pressure in turbine?
Resistance offered by turbine to the steam
What was the first gas turbine car?
The Chrysler turbine car 1962-1964 was the first turbine production car.
What is the differences between pelton turbine and kaplan turbine?
pelton turbines are suited to high head,low flow application but kaplan turbine are used for low head and a large amount of discharge needed. kaplan turbines are expensive to design,manufacture and install as compared to pelton turbine but operate for decades.
Why draft tube is used in francis and kaplan turbine and not in pelton turbine?
The Kaplan turbine is a newer, more revolutionary version of the Francis turbine, which came before it. The draft tube is used so that the turbine does not need to be where the water flow is lowest.
