answersLogoWhite

0

The wiring map sensor tells the diagnostic program. If the problem arises and where the problem is located. The wiring map sensor is located below the dashboard.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?

It is located on the engine block drivers side.


What is the maximum towing capacity of the 2002 Subaru Legacy?

The maximum tosing capacity of the 2002 Subaru Legacy is 2000 lbs..


What is the gap on a 2000 Subaru legacy gt?

.044 inch


What kind of oil does a 2000 Subaru Legacy take?

5w-30


Where is 2001 Subaru Outback vehicle speed sensor?

See the Haynes Repair manual for Legacy & Forester 2000 thru 2006 on page 6-20 section 19.


Where is a fuel filter located on a 2000 subaru legacy B4?

Bernaaaaard Lim


What does the 2000 Subaru Forester knock sensor do?

If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL


Where can you find a diagram for the parking brake on a 2001 Subaru Outback?

In The Subaru Legacy(Outback) Service Manual and the Chilton or Haynes Repair Manual for the Legacy & Forester 2000 thru 2006.


Where is water pump on 2000 subaru legacy?

in with the timing belt change them at the same time


Will a subaru 1993 legacy motor fit in a 2000 outback both standers?

yes


What automatic transmission fluid is recommended for a 2000 Subaru Outback Legasy?

The recommended automatic transmission fluid for a 2000 Subaru Outback Legacy is Subaru ATF HP. This is a proprietary fluid which is sold by local dealerships.


How do you replace the knock sensor on a 2000 Subaru Forester?

Couldn't be easier. Once you locate the knock sensor below and behind the intake manifold, it is held on with one screw through the middle and connected to the wiring harness by one plug. Finding it is the hard part. --Ken