answersLogoWhite

0

5

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the Al value of transformer?

AL means transformer core property


Where is the use of earth transformer?

It is used in where the transformer are connected in star delta.


Why transformer is used?

A transformer used to step up or down the value of voltage.


What will happen if a new branded 132KV transformer is charged at the IR value of 150Megaohm between HT winding and Earth remaining IR values being found infinity?

Sir I am Imran khan in nepal my problem is 6000KVA Step down Transformer is not charging. Transformer Pri- 33000V /105A Sec- 6900V / 502Atransformer all test (open & short circuit ) good . but problem is HT(IR)= value this time IR value 50M ohmBefore 3days HT(IR) = value is 7000M ohm suddenly start Transformer result is Transformer not charging & HT(IR) value is down 50M ohm.


What is the reason for using a neutral current transformer on a transformer?

A current transformer is primarily used at the neutral point of a transformer for earth fault protection. A neutral current transformer will measure any ground fault current which will essentially flow from the star point of the transformer. A fault-detection device other devices is connected to the current transformer and, if the fault current exceeds a certain trigger value, the fault-detection device will give a trip command to an earth-fault relay to disconnect the supply of electricity to the transformer.


How do you improve the ir value of the transformer?

Moisture entered inside the transformer coil may cause loss of IR value. IR value can be increased by removing the moisture. Keep the transformer in a hot air chamber for sufficient time to vaporize the moisture.


What is the ampere range value of transformer?

This typically has to do with how many amps you can safely pull from the secondary of the transformer.


What is a set down transformer?

A stp-down transformer steps voltage down from a high value to a low value. Transformers only work with AC.


What is purpose of ten delta test on transformer?

To ascertain the life of insulation, or effectiveness of the insulation (HV to LV, HV to earth and LV to earth) of the transformer


How do you earth in the 1600 kva transformer?

In 1600 kva transformer we provide NGR (Neutral grounding resistance)


Can an isolating transformer have a center earth tap?

I suppose it could, but then it wouldn't be purely an isolation transformer. It would then be a isolation and either step up or step down transformer.


How do you calculate maximum earth fault current?

transformer max earth fault current