0
That would be a p-trap, like what is located under every sink. This U joint holds water to prevent a sewer smell or odor from the sewer or tank from coming back into the house. It is a trap of water that prevents air gas from reeking your house out!
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What does tos stand for in pipe fitting?
what are some pipe fitting abb
What is meant by fitting allowance?
The fitting allowance is the difference: (pipe end to fitting center measurement) minus (pipe end to end measurement). It is the amount of length the fitting adds to the end of the pipe (to get the center of the turn).
How do you work out x dimensions?
measure the length of the fitting first. Then insert pipe into fitting and mark a line on pipe. measure that bit of pipe. deduct off the length of fitting and half it to give you your x dimension
What nicknames does Adam Fitting go by?
Adam Fitting goes by Pipe.
What type of fitting do you use to connect PVC pipe to unthreaded galvanized pipe?
You can't. There is no fitting to do this. Galvanized has to be threaded.
What is an offset in pipe fitting?
Using fittings to change centerline of pipe.
What are pipe fitting used for?
To join lengths of pipe and to route it where it needs to go.
What is the pipe fitting formula for a 22.5 degree?
Pipe size times 0.707
How do you calculate the surface area of pipe fitting?
To calculate the surface area of a pipe fitting, you need to use the formula 3.14 x L x D. The L stands for the length of the pipe and the D is the diameter of the pipe.
What does SW in pipe fitting?
Sewer waste
Which tool you use in pipe 60 deg layout for pipe fitting?
Swansons square
How do you seal cpvc pipe into brass fitting?
Pipe joint compound or Teflon tape
