To answer this question the wattage of the block heater must be stated. Amps = Watts/Volts.
Check the wattage used by the block heater which should be listed on the heater. If it is 2000 watts or less then the generator will run it.
The answer is simple. The block heater is probably in the 500 - 800 watt range. If it came on new car, your dealer should be able to tell you what wattage it is. KAT'S is known brand and can be purchace at http://www.partsamerica.com/BrandCategories.aspx?MfrCode=FIV stores The 15 amp curcuit you are plugging block heater into has nothing to do with the wattage of the heater. It is only a curcuit breaker that trips if more the 1800 watt is applied to it.
Depends on the waatage of the immersion heater. Read the name plate details of the heater - it shows the wattage of the heater. Assuming the wattage is 1KW (1000Watt) the KHW will be 1KHW if you use the heater for 1 hour.
It depends upon the wattage of the heater.
The Toyota Camry block heater is located on the front of the engine block. You can follow the block heater cord to the block heater.
The typical wattage of a tanning bed bulb is 100W, but you need to check the size of the bed to make sure.
A block heater is not standard equipment.A block heater is not standard equipment.
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.
The 2002 PT Cruiser block heater is located on the front of the engine block. You should be able to follow the block heater cord to the block heater.
The Pontiac G6 block heater is located on the right hand side of the engine. The block heater can be located by following the block heater cord.
Begin by training the water from your 2003 engine block. Remove the wiring harness from the block heater. Remove the block heater retaining bolts. The block heater will come out. Reverse the process to install your new block heater.