A dado blade. A dado blade is 2 saw blades sandwiched around a number of "chisel" blades added or subtracted to achieve the desired width of the saw cut.
a concrete or masonry blade
The size is usually referenced by the largest diameter circular blade which would fit in the saw.
In a church, a synonym for "table" would be "altar" At home, it might depend on the type of table, but I can't think of any alternatives that would work with all types. "Board" is one - as in poetically referring to a table laden with food as a "groaning board".
If the blade has a section that slides into the handle, I would use a 2 part epoxy glue on it. Instruction with the glue. If it has broken clean where the blade meets the handle, there is really not much that can be done. It can be welded, but it would always show the repair.
The blade should protrude at least 1/4" more than the material depth above the table surface. If this cannot be achieved with a 7-1/2" blade, do not attempt the cut. There are ways to achieve the cut by removal of the safety components, but it would not be recommended for the do-it-yourself-er. I have witnessed the effects of improper table saw usage by a skilled carpenter with 20 years of experience. Believe me, it's not worth it.
MDF If you were building a new table, a good material would be condensed particle board.
Ladbroke Grove is not an item, but is the name of a road and the name given to the surrounding area, in the west part of London. There is the Ladbroke Grove tube station, Ladbroke Groove Hotel, Ladbrooke Groove Winery and Ladbrooke Groove cleaners. So, one would assume that Ladbrooke Groove would be good for all of the services available from the Ladbrooke Groove locations mentioned earlier.
Long screw driver with a narrow handle would give the most torque, therefor it would be best It would also depend on the blade of the screw driver. The blade should fit well into the slot in the screw so if the long screw driver with the narrow handle had a small narrow blade that was too small for the screw then another one would be better.
If you want to get a decent used shuffle board table you can try craigslist so when you are ready to buy one you can look at it before you buy the item. The other place I would look is on e-bay but you won't be able to see the shuffle board until you get it. That is the only downfall about e-bay.
i think that pine would be a good wood to use to make a cutting board .
It is the vertical groove in the upper lip,
on the map of woozworld :)