0
What is used to repeat a signal it receives and rebroadcast it?
Wiki User
∙ 11y ago
The answer is a Repeater
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why buffer gate is used?
Buffer gate is like a signal booster, receives input and amplifies it to output
Inputs and outputs of robotics?
An input is when something receives a signal to do something, and an output is sending out a signal. This is usually used in PLC's, or Programmable Logic Control, where an input,(a signal you send to the system) triggers an output, which in return triggers something, like a motor to move.
What does radar measures?
It measures the time it takes for a radio signal of a particular frequency to travel to a target and back. It also measures the strength of the signal when it returns. Based on the travel time of the signal, the radar can measure the distance of the target. Once the radar receives the 2nd signal, it can calculate the velocity of the target. The strength of the signal can be used to determine the size of the target.
What advantage do regenerative repeaters have when used for digital communication?
When any digital signal is transmitted over a pair of wires, it degrades in amplitude. Regenerative repeaters receives the incoming signal, extracts the clock, then regenerates the original signal as a clean digital square wave as if it was the original signal transmitted from the source. Thus the name repeater.
What is the purpose of a communications receiver?
A communications receiver is a radio receiver used for communications. It receives a transmitted signal and sends it further along the line till it is converted into sound.
How do I use my FAB echo guitar peal?
The FAB Echo has two knobs - "Repeat" and "Mix". Repeat controls the amount of times the sound is repeated. It should be noted that rather than echo, this is a simplified delay pedal with no control for delay time. Mix knob is used to control the balance between dry and wet signal (dry signal = no echo, wet signal = only echo). That's it in all its simplicity.
How many types of repeaters are there?
Signal repeaters are generally used in the telecommunication and electronics industries. There can be passive radio signal repeaters, multi-port repeaters, optical signal repeaters for optical fiber and digipeaters which repeat packet data.
How does a LED light works in a motion sensor detector?
Two pairs of Infrared LEDs are used as motion sensor detector. The first one is wired to emit LED and the second is wired to transmit a signal when it receives an infrared input. this infrared is reflected back to the receiving LED and then the signal is produced. This signal can be used to open sliding doors, turn on a light or set off an alarm.
What is the difference between periodic and aperiodic signals?
A signal which repeats itself after a specific interval of time is called periodic signal. A signal which does not repeat itself after a specific interval of time is called aperiodic signal.A signals that repeats its pattern over a period is called periodic signal,A signal that does not repeats its pattern over a period is called aperiodic signal or non periodic.Both the Analog and Digital can be periodic or aperiodic. but in data communication periodic analog sigals and aperiodic digital signals are used.
How can repeat be used in a sentence?
May you please repeat that? I didn't hear you.
For the ancient Romans what object was used as signal for the commencement of a battle?
For the Roman army the trumpet was used as the signal for te start of a battle. It was also used as a signal for retreat.
Chevy Suburban that is not shifting at all-it stays in 1st gear and the speedometer does not move-what could be the problem?
Speed sensor on rear of transmission where speedometer drive used to be. If ecm receives no speed data transmission, it will send no shift signal.
