N$2500.00
my3mp
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
The panel for the heater under wind screen just clips in remove the panel and you will be able to remove the center bezel.
Nevermind. I found the solution through another question.
pry up on the bezel around the shifter then remove 2 screws under bezel. remove 2 screws above radio faceing down remove ash tray remove radio bezel. move bolth seats up on the side of the ctr console is 2 screws remove then remove 2 screws in front of the shifter that are now showing after radio bezel is removed.remove screws located in cup holder crank up e brake and slide console out
Firmly press down on the bezel or cover. Press down into the rear deck. This will release the bezel from the teeth on the metal housing. Now slide it forward ( toward the front of the car) while holding it firmly pressed down into the rear deck. Once removed you will see how the metal teeth on the bottom of the metal housing bracket bit into the plastic bezel.
In the year 2000, the value of the quarter dollar which is 25 cents was $0.25.
2000 dos milguranes to inr value
What is the book value for a 2000 Ford Expedition
2,378 is closer in value to 2000.
Current value is about $4.00
This is quite simple, remove the rubber pads which cover the screws, these are just gently prised out with a small flat bladed screwdriver. Next remove the Philips screws, there are four in the top and two at the bottom. Starting on either side of the display assembly, insert your fingers between the screen and the front bezel and work your way around. The bezel will unsnap. If you are having trouble, work it from side to side until it unsnaps. You may have to slide the latch open to unsnap the bezel. See the link below for detailed information.