because it must be the batteries might be working
antiteft will need to be disabled.
If the lights are not working after using the remote start on a 2003 F-250, then something is wrong with the way it was wired when the remote start was installed. The remote start has wires to hook up to the lights so that a person knows the vehicle started. Perhaps this step was skipped in installation.
Easy just hold down your power button until the light on the remote flashes. Then the TV will come on by it's self.(Note: if it does not work somethings wrong with your remote.)
That means your remote start is in turbotimer mode. Basically the computer starts it up on a routine every once and a while. To stop it you could look in your manual and it should tell you how. If you dont have the manual, remote start it and hit the brake so it shuts off, that should stop it.
If it has a resistor in key perhaps installation of remote changed the resistance value in same Your remote is probably installed wrong .
From the company that made the remote start.
Have someone use your key and start it or install an aftermarket remote starter.
You can use your remote to extend the run time of the remote start event.
the only way to start a car when the remote key is dead is to start it by putting the key into the ignition.
When a remote start device is installed several wires need to be spliced into. All of these are at the ignition switch, my guess is that one end of the splice for the start wire has come loose, unfortunately it is the one going from the splice to the key switch. You'll need to go over the connections to be sure.
No, standard transmission vehicles cannot have a remote start system.
form_title=Repair Remote Start form_header=A remote starter is difficult to repair and is best left to the professionals. How long have you had the remote starter?=_ Please describe the issues you are having:=_ What happens when you try to turn it on?=_