answersLogoWhite

0


Best Answer

were did the tow truck hook the cables at ????????

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What kind of damage would be done to a 97 ford F150 if tow truck hooks cables wrong what could?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a tonneau cover protect your truck bed from damage?

It can help prevent damage on your truck bed. However depending on the weather and the quality of the cover, it could damage the cover itself and from there cause damage to your truck bed.


Why does my truck heater get stuck on hot?

The blend door could be sticking on the truck. The vacuum system could have a leak. Or the cables to the heat valve could be malfunctioning. Check these three areas to fine why your heater is stuck on hot.


What could be some reasons why a 1986 Ford Ranger truck will not start?

Loose cables, bad battery, alternator or starter.


What could make your 2001 Ford F-250 lose power?

my truck lost power also i had bad battery cables


Will insurance total a 2008 Chevrolet 1500 if the frame is bent but there is no cosmetic damage?

This would depend on what it would cost to repair the damage. If it comes to about 70% of the ACV of the truck, then they would probably total the truck. I don't see how an accident could bend the frame of the truck without any cosmetic damage.


Could serious damage occur if the truck had no radiator and was still driving?

Engine may overheat and seize


What could mess up if you jump start the truck and the cables we switched?

You could most likely fry the computer, or possibly ruin other things such as the alternator or mass airflow senser


If car or truck shorts out after connecting battery cables what can you do?

Check fuses.


Where is the thermostat on ram 3500 truck?

Under the housing where the upper radiator hose hooks to the engine.


How do you install heater cables in a 1970 chey c10 pickup truck?

I'm not sure what heater cables are, need more info.


Can you jump start a 6 volt truck from a 12 volt?

Yes, you could but you would damage any electronics on the truck that were on when you jump start the vehicle. I would advise against it.


What do you unplug so truck wont start?

The batterie cables are usually the easiest