Can you mix r134a with r410a?
No, R410a runs higher pressures.
No, R410a runs higher pressures.
Any amount would be a contamination. Charging with clean R410a does not introduce POA oil, which is where a serious contamination would occur. Mixing R410a without oil will simply render that amount of charge in your system as ineffective. To answer the question how much contaminates, it could be seen on a sliding scale, a very small amount, say a couple ounces, probably will not see a noticeable change. A pound, and you would likely notice some changes in performance related to temps. of evaporator as well as the amount of liquid refrigerant its producing to send to the evaporator. As you increase the ratio of R410a to R22, you would only see incrementally worse performance as the compressor is not producing the pressure required to get any use of R410a. If you had somehow introduced R410a with its oil, their would be a serious reason to pull the entire charge, flush the system, and start clean. The oils of R22 and R410a are %100 not mixable, they will be rendered useless, and system damage will occur shortly.
No
No. r410a runs at a much higher pressure.
R22 needs import license,R410A does not need anything special
oil residue in an oxygen regulator connection may cause an explosion. Also when oxygen is mixed in a refrigeration system with a refrigerant like R410A which has oil in it, it can cause an explosion.
The pressure for an R410a air conditioner system should be 118psi LP and 412psi HP. This is the same pressure as an R22 air conditioner.
No
800psig.
No, it is a mixture of two-hydro-fluoro carbons.