0
What else can I help you with?
Can a R410A evaporator be used with a R22 condensor?
No, R410a runs higher pressures.
Will a new r22 coil work with 410 refrigerant?
An R22 coil will work properly with R410A only ifseveral conditions are met.First, the manufacturer of the coil must specify that it will work with both refrigerants. R410A systems operate at about 40 to 70 % higher pressure than R22 systems.Second, the new coil must be equipped with an inlet control (either a thermal expansion valve or orifice) that is intended for R410A. The new coil may not use a capillary tube metering system to control refrigerant flow into the evaporator coils.Third, the tonnage, or Btu capacity, of the coil and control device, and the EER/SEER of the coil must match those same ratings for the condensing unit.Fourth, if the new coil has been used in an R22 system, it must be thoroughly flushed clean of oil, and must be refitted with the proper control valving for R410A.
Is the A-Coil and the Evaporator coil the same thing in central air conditioner systems?
No, the A-Coil and the evaporator coil are not the same thing, though they are closely related. The evaporator coil is a component that absorbs heat from the indoor air, while the A-Coil specifically refers to the shape of the evaporator coil, which resembles the letter "A" when viewed from the side. The A-Coil is designed to enhance airflow and efficiency in central air conditioning systems, but both terms are often used interchangeably in casual discussions.
Can a 410-A evaporator coil be used with a R-22 condenser?
yes
Can you use ester oil in a corolla ac system?
The refigerant gas 134a is used in the evaporator and condensor and many brands of 134a contain ester oils, so yes.
Why ia used a multicircuit evaporator in refrigeration system?
is use when the coil would be come to long for a single circuit
What is commonly used to defrost the ice from the a low temperature evaporator?
Hot gas from the discharge line of the compressor is routed into the evaporator or electric heating elements are embedded into the evaporator fins. Hot gas is often more efficient because no outside power source is needed to defrost the evaporator coil.
What are two methods used to evaporate condensate from the evaporator?
By using the heat from the discharge line and a slinger ring on the condenser fan.
What is an air conditioning evaporator coil?
This is a assembly of a coil of copper or alumnium tubing and fins inside the house heater unit that cools down for the furnance blower to send cold air to the living spaces.
Why is a Multi-circuit evaporator used?
why is a multicircuit evaporator used
If an air conditioner evaporator coils is setup so the refrigerant is vaporized at forty five degrees Fahrenheit What is the pressure in the evaporator coil?
The pressure in the evaporator coil would depend on the type of refrigerant being used. Different refrigerants have varying pressure-temperature relationships. Without knowing the specific refrigerant being used, it is not possible to provide an accurate pressure value.
Can replacing a 10 seer air handler with a 13 seer affect the compressor in the 10 seer condensing unit?
This could actually help your 10 seer condensor run a little more efficiently but make sure you find out if your old air handlers evaporator coil used a cap tube or a expansion valve to meter freon,because if u are going from a cap tube to a expansion valve evaporator coil u will need to add a hard to start kit and time delay for the compressor,or u will wind up hurting your compressor. any service company should be able help u with this. Good luck!
