torx heads. I cant remember the size. might be T15
There are small tork screws on the plastic headlight housings. It is kind of a pain to get to them.
Open hood place latch in place.Remove the two screws that hold the LHS marker light.Behind that are two more screws remove those.Next go to the RHS and do the same.Now there are screws that run on top of the grill at the metal remove all the screws on top.Next in the honey comb part of the grill center area there are aproximately 3 screws remove those.The grill should pull forward if not double check for any remaining screws not removed.Once the grill is out and the marker lights can be left hanging and let the grill hold on those or lean.Now this allows you to remove the 4 screws with the chrome retaining ring around the headlight itself and disconnect the plug behind the headlight and remove burned out light.Install is reverse of this and the small screws holding the chrome around the headlight are kind of annoying to reinstall so take your time and get one started and then do the other 3 then tighten.Once light is in plug connector on headlight then reinstall grill and marker lights.Test your headlight before buttoning up things to make sure it works to save the hassle.
Actually you can do it yourself... but you have to have a special kind of pliers (called "snapring pliers")to remove the metal retainers(2 on each side of the headlight assembly) that attach the assembly to the grille opening panel. They're cheap and you can get them at your local auto store.
corkscrews - screwdrivers - table screws -
corner on the right kind of near the headlight assembly. it has several ports that comes out of it. it is actually a cartridge type filter. so there are also some screws on top of it
high intensity discharge
Halogen.
Ferrari
one that filters oil, and screws onto the mounting plate and seals Try the same kind you removed
9005
Must be a bicyclist- the worst kind of driver in the world.
His Age or younger