It is an electronic speedometer. the sensor is located on top of the transmission. When I looked into getting a new one for my 89 it was about $80 new.
instal turbo and intercooler
no it will not. To fit 97-98 headlights onto a 95-96 240sx you will need these 97-98 240sx parts: headlights hood front fenders front bumper front grill maybe the front bumper support
I do believe it is on the top of the passenger side valve cover. That was where it was located in the 1991 240SX. You want to make sure the car is turned off before you begin looking for it.
the fronts are 4x6 and the rear are 6.5 they make a bracket on ebay to make the fronts 6.5 if you want hope this helps
Not lubricated
116638 is fairly low mileage, but they did not make the 240SX until 1989. My 89 coupe has around 136000 on it (don't know exactly because someone tampered with the mileage)
As far as I know, it should have a gasket. Make sure to use gasket sealer as well when replacing it.
The 1990 Stanza only came with a 4 sylinder.
recommended oil is useally 10-30 for 240sx but i use synthetic high milage 10-40 4qts. only because it's an old engine and if you like the pedal to the medal you'll need that extra lube to make sure the engine doesn't heat up as much use Castorl oil on of the best don't use that pink stuff unless your read it ....
stop when you cant turn the wrench anymore lol. na really does not matter just make sure they are nice and tight
you need to check your lights to make sure that the light is not going out!!! A flashing CEL typicly means that there is a misfire.
I would follow the cable back to the tansmision. Make sure it is intact and connected at both ends.