a motor
The thing that makes my alternator rotate came out what do they call that?
Bad bearing in compressor? Bad bearing in compressor?
If you are only changing the compressor, add 3 ounces into the suction port of the compressor before you attach hoses. After hoses are attached rotate the compressor by hand clockwise several turns to distribute the oil.
It makes noise and cools everything.
The chamber does not rotate. However, the CYLINDER does rotate. Viewed from the rear, a S&W rotates clockwise. Other makes may rotate counterclockwise.
bad clutch bearing
you have to loosen a bolt on the front of the AC compressor, I think its a 12mm. You loosen it and the the AC compressor will then be able to rotate downward, sometimes the compressor gets stuck with age and you might need to tap it down with a mallet. Once the compressor rotates downward the tension in the belt will be gone and you can change the belt. Then tighten the same bolt until you achieve the desired tension
If you have replaced the compressor only, I would add 3 oz directly to suction port of compressor then rotate the comp by hand a few revolutions. If you have not replaced any major part of the system, very little oil, if any would be added.
low on freon or too high pressure or thermostat
Compressor locked up.
Hi the compressor has a device usually a pressure switch that on off loads the head inlet compression valve system. With a screw compressor it is usually a diaphragm operating a piston that open and closes the inlet to the element
Torque