A larger load.
A rheostat is a variable resistor that can increase or decrease the resistance in a circuit. By increasing the resistance in the circuit, the rheostat limits the flow of current, causing it to become higher in the parts of the circuit where the resistance is lower.
The electric force that makes current flow in a circuit is related to the resistance.
The electric force that makes current flow in a circuit is related to the resistance.
Resistance in the circuit makes it difficult for current to pass through.
Circuit
The term, 'overcurrent', describes either an 'overload current' or a 'short-circuit current'.An 'overload current' is a current that is higher than a circuit's 'rated current'. For example, if you have too many loads plugged into the same circuit, then the resulting current is an 'overload current'.A 'short-circuit current' is a large current resulting when a line ('hot') conductor accidentally makes contact with either a neutral conductor or an earth (ground) conductor.
well current in a series circuit wont change so a voltage series is also a current series probablyAnswerYour question makes little sense. Applying a voltage across a series circuit results in current through that circuit, so what exactly are you asking?
No, a wire wrapped around a magnet is an example of a closed circuit, as the wire forms a continuous loop for the flow of electric current. An open circuit is a circuit that is interrupted, preventing the flow of current.
an opened circuit is considered to be possessed with an infinite resistance which totally opposes the flow of current in the circuit and ultimately makes the functioning of elements in the electric circuit subtle
A fuse is an overcurrent protection device, which protects a circuit by melting in the event of either a sustained overload current, or a short-circuit current. A short-circuit current will occur when a line (not 'phase') conductor makes direct contact with a neutral (or earth) conductor.
Inductive reactance case of ac) is equivalent to resistance (in case of dc) for inductors.So if resistance increases current decreasesas well as if inductive reactance increases current decreases
Gives you a direct current. There is a small amount of AC ripple that makes it through.