0
You have a bad o2 sensor (low voltage)
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Check engine light flashing on Isuzu rodeo?
A flashing check engine light means that you have a problem with your engine that may cause harm to the catalytic converter.
What does an engine code of P0442 for a 1998 Isuzu Rodeo mean?
Trouble code P0442 means: Evaporative Emission System Leak Detected (small leak)
Isuzu rodeo whit code p0700 what the means?
Trouble code P0700 means: Transmission Control System (MIL Request)
Isuzu Rodeo dtc p0171?
Trouble code P0171 means: System Too Lean (Bank 1)
What is code p1627 to a 99 Isuzu Rodeo?
Trouble code P1627 means: PCM A/D Conversion Malfunction
Are 2001 Isuzu transmissions sealed?
yes the system is sealed, which means there isn't a dip srick on the side of the motor so you can check the level of the transmission fuild like you would check your engine oil , also owner of 2001 Isuzu Rodeo Sport V6 Automatic.
98 Isuzu Rodeo has code p0351?
Trouble code P0351 means: Ignition Coil A Primary/Secondary Circuit
What does the RrABS light on a 97 Isuzu rodeo mean?
It means the Anti Lock Brake system isn't working properly
What does the code p1326 for a 2001 Isuzu rodeo mean?
Trouble code P1326 means: ION Sensing Module Combustion Quality
What causes the gas brake and battery light to turn on Is their a sensor that controls all of them in a 1995 Isuzu Rodeo.?
when all three of those lights turn on that means that your alternator is bad. i just went threw this same problem with my rodeo
What does each warning light on Isuzu NPR mean?
The engine symbol means you should check the engine, the oil symbol means that the oil pressure is off, the thermometer means that the engine is overheated, and the battery symbol means the generator is malfunctioning. There are many other warning lights on the Isuzu NPR dashboard and a complete description can be located in the ownerÃ?s manual.
How do you fix a code 37 in an Isuzu Rodeo?
A code 37 on an Isuzu Rodeo means to check the transmission. This could mean that a short is occurring between the Transmission Control Module and the Electronic Computer Unit. Check all wires going from the transmission to the computer. If no short is found, a tube might be placed over the wires to prevent them from accidentally coding for no reason other than magnetic interference.
