0
What else can I help you with?
What is the bolt pattern for a 98 Isuzu Rodeo?
5 139.7mm/5.5
Is a 1996 Isuzu rodeo 3.2 crank shaft pulley bolt left hand threaded?
No
What size are he brake caliper mounting bolts on 1999 Isuzu Rodeo?
The brake caliper mounting bolts on a 1999 Isuzu Rodeo are typically 12mm in size. It's important to ensure you use the correct socket size when working on the brake system to avoid stripping the bolts. Always check the vehicle's service manual for specific torque specifications and bolt sizes.
Are the threads on the bolt that hold the tensioner pulley left or right handed on a 1995 Isuzu Rodeo?
Standard rh threads
Would 16 inch wheels fit a 1995 Isuzu Rodeo?
I have 1995 Honda Passport (same as Isuzu Rodeo) and it came stock with 16 inch aluminum wheels. The bolt pattern is 6 lug nuts. The tire size is P245/70 R16 (please note that on tire size the R16 stand for 16 inch wheels)
Do all 6 stud rims fit on a 03 rodeo?
Not all 6-stud rims will fit on a 2003 Isuzu Rodeo. The compatibility of rims depends on factors such as bolt pattern, offset, and wheel diameter. The Rodeo typically requires a specific bolt pattern (often 6x139.7 mm), so it's essential to check these specifications before purchasing new rims. Always consult your owner's manual or a tire specialist for the best fit.
What is the bolt pattern for a 1999 expedition?
The bolt pattern is ; 5x135
What tools are needed to change brakes on a 1995 Isuzu rodeo?
14 mm wrench or socket--top bolt does not loosen--take out bottom bolt and snap out pads -- front and back of each wheel
How do you remove the starter from a 1998 Isuzu Rodeo?
You might have to take the motor mounts bolt and disconnect the exhaust after the Y and at the monifolds and lift the motor slightly to get the starter out.
What is 1999 Dodge Durango bolt pattern?
6 lug 4.5" bolt pattern 6 lug 4.5" bolt pattern
What size are the bolts on a 1995 Isuzu rodeo alternator?
The alternator retaining bolt size is 9/16. The alternator bolts will be three inches long. The alternator tensioner bolt is 9/16 by one inch.
Is the 3.2 v6 in an Isuzu Rodeo made by General Motors?
Yes, and no... GM and Isuzu are partners to some degree. I personly have a '97 Rodeo, and am looking to install a bigger better engine, and have come across several interresting facts. The Isuzu 3.2 liter uses the GM 60 degree V6 bolt pattern to the transmission, as well as obviously the GM V6's do. Currently searching for an '04 3.8 liter pushrod V6 that will use my ignition system (coil on plug) and the MPFI.
