jnjnnin
bar graph
You should use a ruler to measure a fork. Once you have the measurement, it's probably most convenient to describe it in units of centimeters or millimeters, but meters will also work just fine.
A tape measure.
A vernier caliper should be used to measure the diameter of a steel ball.
You could measure the length or width of it but you would have a decimal. You should be using centimeters.
nails
lcds
You should use a ruler to measure a fork. Once you have the measurement, it's probably most convenient to describe it in units of centimeters or millimeters, but meters will also work just fine.
not usually.. but u need to measure the bolt pattern from the toyota to nissan from center to center skipping one hole and measure across, if toyota measures the same as nissan it should fit but make sure you measure the center hole where your hub axle fits, if its the same it will bolt..so there is a way
This will vary from horse to horse. To determine blanket size measure from the center of the horses chest to the center of it's tail and that should be the blanket size, if it is a odd number go up one size.
Between 37 and 49 (Fahrenheit), depending on the ambient air temperature. You measure it with a thermometer in the left center console vent.
at the bottom you will get some value which is positive while if you measure at the centre you will get zero length
A normal distribution is symmetric and when looked at on a graph, the graph looks like a bell shaped curve. Approximately 95 percent of its values should lie within two standard deviations of the mean. Frequency of the data lies mostly in the middle of the curve.
The body should be bilaterally symmetric, meaning that it should be approximately the same on both sides.
The meter should be on the AC scale. In Canada and US the reading should be 240 on the outside blade holes and 120 volt from the outside blade holes to the center blade hole. The U shaped pin is the ground. No voltage from it to the center pin.
If a tornado passes near or over a barometer, it will measure a very rapid drop in pressure. How much the pressure drops depends on the strength of the tornado and how close the center of it comes tot he barometer.
you should always know how to describe your answer
describe when a budget revision should be refused.