The inertia switch has tripped. It is in the Passenger side (UK) just under the glove box on the side. Remove the cover and reset by pushing down the button.
You may not have any spark, you need to check for spark with a spark tester..If you do not have spark it could be caused by your spark control modulel,bad coil ect.find out why you have no spark...Have you been having problems before with the truck turning off or stalling, prior to this? If so then i would suspect the spark control module.
It might, But 1 thing is for sure, it will smoke black and fuel foul the spark plugs out and won't run worth a ------------.
A thing starting with G is garage.
iv had the same thing happen to me ther are a fue things i might be 1 the coil lead is old and not carrying spark 2 the coil is stufft 3 try unpluging the wires to the coil and cleaning/spraing them and do the same to the computer
Spark plug order? there is no such thing.
I don't know! I want to know the same thing :( :(
It is almost unlimited, the only thing is that it requires resources from the computer so if you have a lot of spark-lines it might work slow or even collapse at the end.
there are three things that make a vehicle run: spark.gas and air. Without one of the three, the vehicle will not run. A simple test is spay starting fluid straight into the carborator or throttle body. If the engine tries to start, then it is a fuel problem. the second test is to take the spark plug wire and hold it next to a grounded surface. if you see a spark while the engine is starting, then the spark is okay. The last thing to consider is if the timing is off
Yes
that one thing.
First Thing to Look at Is check the fuel pump , Make sure you are getting Fuel up into the engine it is possible that one of the relays could be bad , which could stop the vehicle from starting
commetments confidence and spark to do some thing