0
Mixing valve usually for tempering domestic hot water.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
In boiler feed water line whether a non return valve should precede or succeed the delivery valve of feed water pump?
In boiler feed water line the NRV is normally installed between Pump and stop valve if the line is short and an another NRV is installed at boiler entrance and after stop valve if the line is long or pump is 10 to 15 m away from the boiler.
What is boiler corrosion?
the decay of boiler material by chemical or electrochemical attack by its environment is known as boiler corrosion
What is main purpose of refractories of boiler furnace?
one of the main purpose of refractories in the boiler furnace is to
What gas boiler alleviates the need for cwsc f?
what gas boiler alleviates the need for a cwsc
What is the difference between the operation of a automatic boiler and manual boiler?
boiler are working on same principal but automatic and manual boiler has difference that manual boiler working at single element loop and automatic boiler work at three element loop.single loop means when fuel increase mean load increase on boiler by adjusting fuel operator has to adjust steam drum level manualy , while automatic means when load increas, fuel increase steam drum level adjust automaticaly by watching fuel consumption.
Why two safety valve provide to boiler?
standby valve,
How do you test a safety valve of a Boiler?
Raise the pressure in the boiler until the valve relieves and note the pressure at which it does so.
What is the application of boiler stop valve?
Stop Boiler Valve (or Crown Valve) is installed on an outlet line of a boiler. It's purpose is isolation of a boiler from a downstream steam line. Its position may be either open or close, it cannot be used for throttling of steam.
What is the feed check valve of boiler?
The feed check valve of a boiler is on the line coming out of the boiler it is usually to prevent the water from going back in to the boiler its coming out of so it would build up excessive amounts of pressure which will cause the t&p valve to blow temperature and pressure
What are the safety of boiler safety valve?
Safety valve simmering how can setting
How do you size a boiler relief valve?
The relief valve should be at least as large (in BTU/hr capacity) as the input of the boiler. A 3.5 million input boiler would need then a relief valve to handle at a minimum 3.5 million BTU/hr.
What is the difference between a sillcock valve a boiler valve and a hose bibb valve?
They are just about the same
How do you bleed air out of baseboards that have no bleed valve?
By using the bleeder valve by the boiler
How do you change a mixing valve in a faucet?
mixing valve in a faucet: ok I will assume you are refering to a shower valve, that is the only faucet w/a mixing valve: shut off the hot and cold water. cut out valve or unsweat it. clean and flux new valve, pipe and fittings(if used) sweat in new valve
What is a tricock valve?
It is a small, valve usually used to manually check if water is above the valve connection on a boiler or tank. There may be several of them at different heights on the boiler or tank. There is a handwheel on the valve, an inlet connection (which is attached to the boiler) and an outlet (usually left unconnected). When filling the boiler or tank, the try-cocks can be left open. Water coming from the try-cock means the tank is filled to at least that level. The valve is then closed.
What is a boiler check valve?
*A boiler check valve is usually made by Watts and called a Watts 9D. This prevents the water that goes into the boiler backflowing and having the heating water from the boiler coming back into the domestic water and having you drink it or shower in it.* Cheers,QuiteSomething
In boiler feed water line whether a non return valve should precede or succeed the delivery valve of feed water pump?
In boiler feed water line the NRV is normally installed between Pump and stop valve if the line is short and an another NRV is installed at boiler entrance and after stop valve if the line is long or pump is 10 to 15 m away from the boiler.
