step-down transformer
A switch basically represents a gap in the electric circuit. Electric current can pass through a circuit only if it is complete. An incomplete circuit can never pass a current through it. When the switch is in the 'off' position, the circuit has a break (gap) in it. When you put the switch in 'on' position, the circuit wire join and the circuit gets completed.
the maximum short current that can be safely break by the circuit breaker.
It depends on the insulation provided in winding, motor can safely run on full load current. and over that it may burn but depends on cooling system of the motor. Motor can burn if insulation fails, failure of insulation depends on only the temperature rise.
Because a short allows/causes very large current flow, which "overloads" the wire [conductor]. When a conductor [wire] carries much more current than is safely capable, then the conductor heats up, and can cause enough heat to ignite the insulation and adjacent combustible materials on fire.
Theoretically, human beings can sit safely on an individual overhead line conductor, providing no part of their body comes into contact with another conductor or the earth. In practise, of course, it's another story as it's highly improbable that anyone could approach a high-voltage line in the first place!
It determines the amount of electric current it can safely carry
Difference between conventional current and electric current? • Electric current can be either negative or positive, but conventional current is always positive.• The conventional current for an electron flow is positive, whereas the electrical current is negative.• For a flow of positive charges, both the electric current and the conventional current are the same.• Since almost every electrical circuit uses an electron flow, it can be safely stated that the conventional current = - electrical current.• In conventional current, the flow of electrons is assumed as a flow of protons on the opposite direction.
If you are not talking literally about cutting a socket and are referring about the sockets circuit, then all that needs to happen is, a switch needs to be cut into the circuit.
3 hours
Primary current is a flow to be measured that cannot be safely passed through the measuring device. A current transformer is used to provide a lower level, secondary current that can be passed safely through the measuring device. Primary current is measured as a secondary current, multiplied by the turns ratio in the current transformer.
A switch basically represents a gap in the electric circuit. Electric current can pass through a circuit only if it is complete. An incomplete circuit can never pass a current through it. When the switch is in the 'off' position, the circuit has a break (gap) in it. When you put the switch in 'on' position, the circuit wire join and the circuit gets completed.
dfjakl;jdfkljafkld
You can add up to 4 inches to your height safely and effectively. Visit http://www.heightsecrets.com
The large majority of fires can be put out safely with water. The exceptions are electrical, grease, or some super heated metals.
Wire gauge is a measurement of how large a wire is, either in diameter or cross sectional area. This determines the amount of electric current a wire can safely carry, as well as its electrical resistance and weight per unit of length.
it depends on your current weight, consult your doctor about how much you should lose, and then work out a plan to safely achieve your goals.
They are not directly touching the ground. There is no way for the electrical current to complete itself if it went through the bird. If you were to stand on the ground and touch the wire you would be 'zapped', for you completed an alternate route for the electricity to take.