Any Japanese petrol driven motor vehicle made post 1985 should run on Unleaded without modification
It depends on the size and weight capacity of the fork lift in question. Also, unless you are speaking of a licensed and road-worthy vehicle which operate on the public streets, I do not believe that the light or heavy commercial status applies.
This varies by country. In New Zealand, a light commercial vehicle refers to a utility vehicle, van, or any other light (under 4500kg) vechicle that is not specifically designed for private passenger usage. SUV's are considered as passenger vehicles. In the US, as I understand at least, the light commercial defintition is not used, and instead, the two main categories used in official vehicle usage statistics are trucks and cars. In this case, SUV's, vans, and utility vehicles are considered trucks.
The color for any tail light on a vehicle is red.
Have vehicle scanned to determine the problem
Have vehicle scanned to determine the problem
u need to replace the flasher unit in the vehicle
There is a problem with the SRS in your vehicle. This is not a DIY repair. Take it to a professional ASAP.
Problem with emission system. Have vehicle scanned to determine the problem
There is no OBD connection on a 1990 Nissan as that is an OBD1 vehicle not OBD2. However there is a way to read the codes. https://codes.rennacs.com/Petrol-Engine/Japanese-Korean/Nissan-Engines.php
Resetting the maintenance light on a 1999 Nissan Altima requires access to the engine compartment of the vehicle. Once their locate the battery and disconnect the negative cable for 5 seconds. Doing so will allow the system to reset.
How do i reset my service light on my 2004 Nissan
To change the fog light on a Nissan Frontier you will need to remove the screws which hold the light assembly in place. These screws may be located under the hood or off to the side of the light on the front of the vehicle. Unclip the plastic relay holding the light in place. Clip the plastic relay into the new fog light and reposition the light in place. Secure the light assembly in with the screws.