0
Add your answer:
Earn +20 pts
Where is the egr valve located on a 1997 Nissan altima?
The EGR valve in a 1997 Nissan Altima is located at the top of the motor in a position near the firewall. The EGR valve is held in place by a vacuum line and 2 nuts.
How many lug nuts the Nissan Altima has?
on a 2010, it has 5
Will 20 inch rims fit on a 1997 Nissan altima?
I've seen '97 Altimas with 20inch rims on them. You will need to buy rims that need the same number of lug nuts your current ones have.
What are the size of the 2007 Nissan Altima Lug Nuts?
the nuts are 12mm x 1.25inch long from http://www.vehicle-bolt-pattern.com/nissan-lug-reference-guide.html
What is the torque specs for the lug nuts on a 2001 Nissan Altima?
It is 87ft. lbs. My owners manual for the Nissan Altima 2001 says exactly, "72 to 87 ft-lb (98 to 118 Nzm)."
What is the correct torque specs for the lug nuts on a 2003 Nissan Altima?
72 to 87 ft lbs.
How do you adjust brakes on a 2000 Altima GXE?
All of the brake pads on your 2000 Nissan will have adjustment nuts. You can turn the adjustment nuts to tighten or loosen the brake pads.
How 1999 Nissan altima wiper linkage repair?
The 1999 Nissan windshield wiper linkage is held in place by three retaining nuts. Remove the retaining nuts and the linkage will come free. Replace the linkage with new linkage.
How do you remove EGR Valve 1995 Nissan altima?
First, unplug the vacuum line. Then remove the two nuts it should lift right off.
What is the correct torque specs for the lug nuts on a 2001 Nissan Altima?
The Torque Spec and assuming you didn't change your rims, 72-87 ft. lbs Anyone who tells you 100, are ignorant.
How do you change a tail light in a 2004 Nissan Altima?
unscrew 2 nuts from behind it and pull out the whole light housing from the outside. This will allow you to reach the light inside it. EZ No prying open aluminum or fiberglass
Where is the egr valve in a 97 Nissan Altima?
It's round and gold. It's located right on top of the motor near the firewall. there is one vacuum line and 2 nuts holding it in place. hope this helps.
