Drill cases are made of plastic to keep the operator from being electrocuted. This is called "double insulation" - the wiring inside the drill is insulated, and the case of the drill is a second insulator. Some of the gears in a drill are made of nylon because nylon is strong enough for the application and it's less expensive to form into a gear shape.
no, plastic is made out of oils usually petroleum.
Plastic.. Depends what type, but plastic pipes are made from plastic. :)
the headlights are made from plastic
Thermoset plastic is what valve covers are made of. Sometimes they are made of metal, but normally it is plastic.
Drill cases are made of plastic to keep the operator from being electrocuted. This is called "double insulation" - the wiring inside the drill is insulated, and the case of the drill is a second insulator. Some of the gears in a drill are made of nylon because nylon is strong enough for the application and it's less expensive to form into a gear shape.
A drill is made of steel and plastics
The same as for wood or metal, just keep the rpm's down to keep from melting the plastic.
Most hand drills are made of steel. Their drill bits are made of high sped steel.
Drill bits are made of steel, and often coated with titanium or cobalt.
JB Weld
There are two different types of tools to do this. Ask for a 'spade bit' or 'hole saw' at the hardware store. Either one is used with an ordinary power drill. When cutting through plastic with power tools, do not run the tool at maximum speed as the friction may melt the plastic and make the cut edge less clean.
Use a carbide bit in a drill. Then install plastic anchors where the screws go.
Plastic, rubber, metal and a motor
I have cut and drilled many plastics and have not found a dedicated set for that. I use regular drill bits and blades and reduce the speed, so as not to melt or burn the plastic
Take a piece of wood and drill 5 holes evenly into the wood. Insert plastic rods into the holes and then place wooden beads over the plastic rods and you will have an easily made spike abacus.
no, plastic is made out of oils usually petroleum.