JB Weld
Get a plastic sheet and then cement it
It is hard to fix the hole in the ozone layer. It is because ozone hole is very big in size.
To fix a screw hole that is too big in wood, you can fill the hole with a wooden dowel or toothpicks dipped in wood glue. Once the glue dries, you can re-drill a smaller hole and insert the screw.
The only fix not involving removing the door panel is to use plastic and tape to fill the hole.The only fix not involving removing the door panel is to use plastic and tape to fill the hole.
First identify the 'plastic' then find it's solvent.
just farking use a bit of double sided tape mate
Because they do not have an edge or point that is sharp, they are less accurate and less refined. If you must fix a blunt nail, drill a much smaller hole first
To fix wood holes for screws, you can use wood filler or a wooden dowel. Fill the hole with wood filler, let it dry, then sand it smooth. Alternatively, insert a wooden dowel into the hole, cut it flush with the surface, and drill a new pilot hole for the screw.
Yes you can although it will be very hard to drill screws into it!👍✌💪
I had the same problem and fixed it. Your air conditioner run off tube is plugged. It is located on the drivers side on the floor near the center console. It is in the corner of the floor board. If you pull the carpet up, you will see a plastic L shaped tube. To fix the problem, just drill a hole in this tube, and put a clothes hanger into the hole to release the clog. After that, fill the hole with Epoxy.
find the right size helicoil and drill out the hole to the proper size and install
You can try fusing some plastic to it, but the reality of it is that it's done for. Toss it, get a new one.