answersLogoWhite

0

just farking use a bit of double sided tape mate

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you fix a hole in a wall?

Get a plastic sheet and then cement it


How do you fix a hole in hard plastic then drill it?

JB Weld


Water floor galant?

I had the same problem and fixed it. Your air conditioner run off tube is plugged. It is located on the drivers side on the floor near the center console. It is in the corner of the floor board. If you pull the carpet up, you will see a plastic L shaped tube. To fix the problem, just drill a hole in this tube, and put a clothes hanger into the hole to release the clog. After that, fill the hole with Epoxy.


How can I fix a bike tire tube?

To fix a bike tire tube, you will need to locate the puncture, remove the tube from the tire, patch the hole with a patch kit, and then re-inflate the tube before putting it back into the tire and reattaching it to the wheel.


How to quick fix a dodge caravan se 2000 window?

The only fix not involving removing the door panel is to use plastic and tape to fill the hole.The only fix not involving removing the door panel is to use plastic and tape to fill the hole.


What is the fix for a low pressure fuel leaking from a small plastic tube near the top of the pump?

The fix is replacing the leaking part.


How do you fix hole in gel ice pack?

You can try fusing some plastic to it, but the reality of it is that it's done for. Toss it, get a new one.


How would one fix a hole in a gas tank on a 1999 Plymouth Voyager?

There is no safe way to repair a plastic fuel tank, you must replace it.


How do you fix the ozone hole?

To fix the ozone hole, stop using CFC's. They are the ones depleting ozone.


How can I fix a hole in the crotch of my jeans?

You can fix a hole in the crotch of your jeans by sewing it up using a needle and thread or by using a patch to cover the hole.


How do you fix hole in gas tank?

take it to the fix place...................................................................................................................................................................................................................................................................


How do you replace or fix the coolant tube behind the water pump on a 92 Geo Metro 1.0L The coolant tube seal to the engine block has been broken?

Ouch, tough one. You might be able to have a machine shop drill and tap a hole that would let you screw a pipe in to hook up a tube. It would depend on what is directly behind that hole in the engine. Consult a machine shop or mechanic.