Power is voltage times amperes, so 28 volts and 4 amperes is 112 watts.
The reason for this is that voltage is actually joules per coulomb, and amperes is actually coulombs per second. Multiplying them together produces joules per second, which is the definition of watts.
P = I x V P = 22 x 220 Therefore Power consumed = 4840 Watts Or 4.84kW
Here is my full question - A typical 120-volt household circuit delivers 350 watts of power to an appliance, and another 10 watts of power are consumed by the circuit. There is no ground fault. a. How much current is carried by the hot wire? b. How much current is carried by the neutral? c. How much current is carried by the grounding conductor? d. Calculate the resistance of the circuit: by "consumed by the circuit" I assume you mean consumed by the wires. Assuming resistive loads only, the total load is 360 watts, thus the current is 3 amps. The current flows in the hot and the neutral.
A 120 v circuit would supply 120 v to both resistors if they are in parallel, which is 120/100 amps into a 100 ohm load, and 120/80 amps into am 80 ohms load, which totals up to 2.7 amps, so the total power is 120x2.7 watts or 324 watts.
Amps is a measure of current flowing in a circuit. Volt-Amps or (VA) is a measure of power and is equivalent to wattage for a pure resistive load.
Power = E times I = (24 x 2) = 48 watts
The circuit would be protected up to 8 amps before the breaker would trip. Any more that 8 amps and the circuit would open and shut the circuit off.
Without knowing the resistance present or the power being consumed, it is not possible to determine how volts are present in a circuit with 63 amps. Ohm's Law: Voltage = Current times Resistance Volt: Joules per CoulombAmpere: Coulombs per SecondWatt: Joules per Second
200 amps
Answer: To determine the amperage in a circuit. Notes: Power (in watts) = Volts * Amps 16.4 KVA = 480V * Amps 16400 / 480 = Amps ~34.2 = Amps
80% of the rated circuit. 10 amp circuit is 8 amps, 20 amp circuit is 16 amps, etc.
The equation that you are looking for is I = E/R. Amps = Volts/Resistance.
.9 watts.