0
What precaution should be taken prior to recovering refrigerant from a chiller suspected of having tube leaks?
Wiki User
∙ 15y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What precaution should be taken prior to recovering refrigerant from a chiller suspected of having tune leaks?
Run the circulating pumps
What precautions should be taken prior to recovering refrigerant from a chiller suspected of having to leaks?
Run the circulating pumps
What is the difference between vrv system and chiller?
Chiller uses chilled water while vrv uses refrigerant directly
What should be done to reduce refrigerant loss from a purge unit on a CFC-11 chiller?
Leak test and repair the chiller.
What is the chiller condenser pressure?
According to state of the outlet refrigerant from compressor, it's better we use refrigerant temperature.
When a chiller is used the secondary refrigerant that circulates in the building is?
Water
What is the relation between ahu and chiller?
The AHU uses the cooled refrigerant incoming through pipes from Chiller to cool the supply air of the cooled area.
How many pounds of refrigerant are in a carrier 19DK 242 ton chiller?
600 lbs
What is the correct suction pressure whin charging a chiller using refrigerant 134a?
926.5
How water chiller works?
Water cooled chiller work on principal that water is circulated in condenser for removal of heat from the system and refrigerant gas is thus condensed in condensor.
Where is the rupture disc located on a low pressure chiller?
the rupture disc is piped off the chiller barrel (evaporator) and will vent the refrigerant outside incase of over pressure of the unit
What is chiller approach temperature?
Evaporator Approach is the difference between the evaporating refrigerant temperature - measured at the well in the evaporator -and leaving chilled water temperature.Take all readings with the water cooled chiller at full load.Condenser Approach is the difference between the liquid refrigerant temperature - as measured on the liquid line - and leaving condenser water temperature.
