The purpose of a Hemoguard stopper on an ETS tube is to prevent any blood or fluid from leaking out of the tube during transportation or handling. The Hemoguard stopper is designed to create a tight seal and provide a barrier against any potential leaks or contamination. This helps ensure the integrity of the sample and maintain the accuracy of test results.
It is soluble in water.
A beaker cover is called a rubber stopper or metal stopper(depends on what the stopper is made of).
never attempt to insert glass tubing that has a jagged end, all glass tubing should be fire polished before its inserted into a rubber stopper. Use water or glycerin as a lubricant at the end of the glass tubing before inserting it into the rubber stopper. ask teacher for proper lubricant. Protect hands and fingers by wearing leather gloves or placing a folded cloth between your hands and the tubing. hold it as close as possible to the part it is inserted to the rubber stopper. always point the tubing away from the palm of your hand that holds the stopper. use a twisting motion and push the tubing into the stopper. At the end of the experiment put on leather gloves or place the folded cloth between your hands and the tubing and remover the stoppers from the tubing to keep them from sticking to the glass. if it wont budge, use lubricant.
rubber stopper burst up because it has strong afinity with hydrogen
Glycerin is often used as a lubricant for this purpose (and others).
i don't know... That's why I'm asking you. soo.. Does a rubber stopper float in water?
Since the difference in volume corresponds to the volume of the stopper, the volume of the stopper=30.9-25=5.9ml Thus density of the rubber stopper=mass/vol=(8.46/5.9)g/ml
What is the purpose of wetting the glass tubing before inserting into a stopper?
The purpose of a Hemoguard stopper on an ETS tube is to prevent any blood or fluid from leaking out of the tube during transportation or handling. The Hemoguard stopper is designed to create a tight seal and provide a barrier against any potential leaks or contamination. This helps ensure the integrity of the sample and maintain the accuracy of test results.
If the stopper has an airtight seal, the pressure in the bottle will increase, with the same amount of air and water confined to a smaller area.
The purpose is to allow an easy insertion.
yes
By carrying out the water displacement method
Run warm to hot water over the neck of the container. This will expand the neck and the stopper should come out.
It is soluble in water.
it is stopper =]