0
What else can I help you with?
What gauge wire for service entrance in Wisconsin?
Depends on the size of the service. 100 amp service will require 3 gauge, 150 amp service will require 1/0 gauge, and 200 amp service will require 3/0 gauge.
What gauge of service wire should you run for 100 amp meter?
My memory says correct gauge for 100 amp service is 1 0 (that is, one ought) I could be wrong, check with your power company or building inspector.
What gauge wire to use for 70 amp service going 200' underground?
I would recommend you use 1/0 gauge
What wire gauge is needed to carry 150 amps at 240 volts?
At the service entrance you will need AWG 1/0 gauge.
What gauge electrical wire is required to upgrade your electircal service to 200A if your incoming service is underground?
4/0 Aluminum or 2/0 Copper type USE.
What wire gage for 130' supply 100 amp service?
I would run 1/0 gauge.
What gauge of cooper service wire for 200A service to meter box and service panel?
For a 200A service, the recommended copper wire gauge for service entrance cable is typically 2/0 AWG (American Wire Gauge). This wire size is able to handle the ampacity required for a 200A service safely and efficiently. It is always recommended to consult with a licensed electrician to determine the appropriate wire size for your specific installation.
Is a pencil a size 0 gauge size?
No, a pencil is not a size 0 gauge size but a 4 gauge.
What size aluminum wire should be used for a 200 amp service?
For a 200 amp service, a minimum of 2/0 gauge aluminum wire should be used.
How much is activation fee?
The activation fee typically varies depending on the service provider and the type of service being activated. It can range from $0 to several hundred dollars. For accurate information, it's best to check with the specific company or service you are inquiring about, as they will provide the exact fee details.
What size USE wire is needed for 200 amps?
As a service entrance wire you need AWG # 3/0 gauge copper.
What type of entrance cable should be used for a 100 amp service?
For a 100 amp service, a minimum of 2-gauge copper or 1/0 aluminum entrance cable should be used.
