0
What setting should you have your pool on for normal operation?
Wiki User
∙ 15y ago
If you're talking about your pool filter, it should be set to filter or run. Use the bypass or recirculate setting if you wish to circulate the water without having the water pass through the filter. Use the backwash setting to clean the filter.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What setting is used for normal operation of a pool while swimming?
If you have a sand or DE filter the setting is filter in the case of cartridge filters it is filter as always unless there are other settings for your particular setup.
What setting should the sand filter be at when using the the above ground pool cleaner?
It should be on "FILTER"
What is a normal pH balances in a pool?
Normal pH should be between 7.4-7.6
Waste setting on pool filter?
The "Rinse" will also take water out, but you should really have a waste setting. Call a local pool company or the maker of your filter system.
How do you vacuum your salt water pool?
You can vacuum a salt water pool the same way you would a non salt water pool. If you are vacuuming on the filter setting, your filter will help to clean the debris out of the pool. If you are dealing with a very dirty pool and use the waste setting, you will be wasting some of the water from the pool in the process. Depending on how much water you take out and need to refill, you will most likely need to add some salt back in to get your salt level back to normal operating levels.
Should a pool be drained for normal maintenance?
Yes because the bacteria from not cleaning it will harm u
What is the normal gauge pressure for a 30' round above ground pool?
THE NORMAL GAUGE PRESSURE SHOULD STAY AROUND 12 TO 19 P.S.I
How long should pool pump filtration time be during summer and winter months for saltwater pool Does extra hours of operation wears equipment out How about electricity cost per hour save?
ne hour
How do you keep desert frogs from getting in your swimming pool?
Have you tried a nylon mesh stretched above the surface of the pool It would take a bit of setting up but should work. Have a look at pool safety nets for inspiration. I will put in a link to one of them
How do use a multi valve pool filter?
Need more specific info A multi valve pool filter is a common configuration of valve and filter for a swimming pool system. The piping into and out of the filter is attached to a multivale. A multivalve has has several positions. One type of multi valve has six positions: backwash, waste, filter, closed, rinse and recirculate. (These valve positions are used on a DE filter. A sand filter may be different.) Use the filter setting in the nromal operation of your pool. This setting receives water from the pump and directs it to the dirty side of the filter media and then receives weater from the clean side and directs it to the pool. Use the Backwash setting to flush the DE from the filter and to a drain. Use the waste setting to flush water directly from the pump to the drain. The closed position is, well, closed. Rinse? Recirculate?
I live in Memphis Tn and I would like to know if you think my pool has a leak or is this normal evaporation My pool is 10 x 32 by 4 feet deep is this normal or do I have a leak?
A good way to see if you have a leak in your pool is to # take a bucket and fill it with water from your pool. # mark it at the water level. # mark the pool at the water level. # wait a few days if there is no leak in the pool then the water level in the bucket should have reduced by the same amount as the water level in the pool, however if the water level in the pool has gone down more then the water level in the bucket you have a leak in the pool or in the pipes around the pool.
How long should it take to build a custom pool?
Depending on the type of pool, the weather and the amount and type of deck to be installed, from one week to four weeks should be about normal for any type of installation. Weather can greatly affect the time though.
