1st,check the main plug of electric wire just to make sure if the wire is damage..
2nd,try to seek for more electrical wire if there are any electric wires damaged to prevent fire
3rd,if you have any relatives that knows a little about electric problems,ask them how to prevent fire
4th,remove some dust near the electric damage wire cause if the dust stick into the damage wire,it's like a paper and it can burn swiftly
5th,remove the plug for a while to make sure that the electric shock will not occur again..
"sorry if i have any wrong english grammars about my answers XD"
report to supervisor
It actually depends on which theory you care to try. Some people theorize that if you generate an electrical shock big enough, it will fry and even evaporate water. I'm guessing a continuous shock of a lower volt would do the trick as well.
Yes, a person can die of shock. When a person goes into shock they must be taken to a hospital immediately to receive the proper care.
The hazard is electric shock, flasover, short circuit, fatality. Care should taken to use right tool for roght application. The tool must sutably insulted. The person using the tool must be qualified and trained to do the said job.
The heater can most likely not be shortened. If ceramic tiles were installed then they will have to be cut to expand the opening with great care. The tiles will have to be wet, and the right blade used to prevent shattering. This is cutting wet tile with an electrical tool so electrical shock must be considered.
Check for a pulse; if no pulse resume CPR. The AED will reanalyze in 2 minutes.
you should take care to ensure that the circuit components being analysed are isolated from the power supply. only carry these test out if you are completely confidnet that your safety is guarranteed from a possable electric shock. you should also take care to ensure that the electrical contact restistance across your fingers and hand do not give a false reading where they would allow a leakage of small electrical current thruogh your fingers if you choose to hold your measuring probes of the meter onto the restance - component with your fingers directly. although this isnt reccomended . you should use approved equipment designed to connect to any terminals or components safely ; crocdile clips .
Saves money/resourceces.
It created a new market for antidepressants and shock therapy.
The incision should be watched for signs of infection. In general, no special wound care is required.
i dont know dont care
You can do this easily if you buy ceiling speakers. These are often ceiling or wall speakers. You should take care to avoid electrical wiring while installing.