remove the slide,return the low-power objective, use lens paper to clean the stage of microscope and the lenses
Remove the slide ,return the scope to low powered and ,turn off the light .
Replace the missing part.
AnswerYou should remove slide, retun scope to low power, turn off light, clean the lens(if asked) and put it away.
Turn the microscope off
Remove the slide or sample. Turn off the lamp or light source. Turn off power at power point. Gently wind down the higher magnification to the stop position. Clean the objective lens if oil was used ( to stop the oil oxidising on the lens). Cover the microscope to protect from dust. Carry with two hands, one under the base, the other on the neck or column. Store away from heat, light and moisture.
Remove the slide ,return the scope to low powered and ,turn off the light .
Remove the slide ,return the scope to low powered and ,turn off the light .
Put it in a safe place. And clean it first
Remove the slide ,return the scope to low powered and ,turn off the light .
Remove your eyes from the eyepiece of the microscope.
Research should be done whenever information is needed.
The light must be off
Replace the missing part.
It will bring an object into focus..
you should make sure the microscope is clean and ready. and that it is set on the right setting. i actually have no clue . suckerrr
Report it to someone in authority.
AnswerYou should remove slide, retun scope to low power, turn off light, clean the lens(if asked) and put it away.