Want this question answered?
Look at the charging chart in the unit for the answer.
On smaller residential air conditioners the manufacturer publishes a charging chart that has the outside air temperature and the corresponding suction and liquid pressure measured by a refrigeration manifold set, gauges. If the chart is not available, you can estimate by measuring the suction pressure and then using a pressure temperature chart for your refrigerant and trying to maintain a 35 degree to 40 degree temperature at the condensing unit or compressor. The other measurement on larger units is the subcooling measurement, measure the actual liquid line temperature and compare the liquid pressure using a pressure temperature chart and also checking for bubbles in the liquid line sight glass. On larger systems after the subcooling has been checked then the superheat has to be checked and the thermostatic expansion valve adjusted if necessary. To check the superheat, measure the suction pressure, convert to a temperature and then measure the actual suction line temperature. The difference is the superheat, should be 6 to 20 degrees depending on the system.
20 low 265 high
No. A Newton is a unit of force, while pressure is force per unit area. The standard unit of pressure is a Pascal, which is also a derived SI unit.
it will be danger the compressor
60psi
Suction pressure
Look at the charging chart in the unit for the answer.
Read the charging chart specific to the unit. Not all 410A machines will operate at identical pressures in identical conditions.
pound per square inch
I guess that would be measured in units of pressure: Pascal = Newton/meter2.
On smaller residential air conditioners the manufacturer publishes a charging chart that has the outside air temperature and the corresponding suction and liquid pressure measured by a refrigeration manifold set, gauges. If the chart is not available, you can estimate by measuring the suction pressure and then using a pressure temperature chart for your refrigerant and trying to maintain a 35 degree to 40 degree temperature at the condensing unit or compressor. The other measurement on larger units is the subcooling measurement, measure the actual liquid line temperature and compare the liquid pressure using a pressure temperature chart and also checking for bubbles in the liquid line sight glass. On larger systems after the subcooling has been checked then the superheat has to be checked and the thermostatic expansion valve adjusted if necessary. To check the superheat, measure the suction pressure, convert to a temperature and then measure the actual suction line temperature. The difference is the superheat, should be 6 to 20 degrees depending on the system.
The suction line is the big one. This line should be cold when the unit is on. The small line is the liquid line.
You need a chart which identified the relationship between the ambient air temperature and the pressure, as well as a manifold gauge set.
The pressure gradient force is not actually a force but the acceleration of air due to pressure difference (a force per unit mass).
With the unit running, front seat the liquid line valve and monitor the pressure. Once you have the unit in a vacuum, front seat the suction side and cut the power to the unit.
what is the charging schedule for a 2 1/2 ton unit 70degree ambient temp what is the suction pressure supposed to be