0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can gas condensate be used in place of diesel?
No, It's too flammable. There should be a compression compartment.
What does geo and graphein mean in English?
geo it's mean earth and graphein it's mean study
What is the type of stress for a reverse fault?
In a reverse fault the maximum principal stress is horizontal, compression causes reverse (thrust) faults.
What is the force that squeezes rocks together?
Stresses the squeeze rocks or anything else are compressive.
Compare the way that compression affects the crust to the way that tension affects the crust?
compression and tension are opposite. compression pushes the crust together but tension pulls it apart
What should compression be on a 1.0 geo eng?
156psi or higher
What should the compression readings for a 1993 geo storm 1.6L be at?
150 psi
How do you fix a code p0400 on a geo traker?
The code P0 400, in your Chevrolet Geo tracker, is a reference to the ABS braking system not working properly. In most cases when the ABS braking system is not working properly you will need to change the sensor.
How you say traker in Swahili language?
In Swahili, "tracker" is "msakaji."
Why does my Geo Metro die at low idle?
low compression, if over 100000 miles, needs new rings
What is the torque compression spec's for 1994 Geo Metro engine exhaust and flywheel?
Replacing engine and need information.
Troubleshooting 1996 Geo metro?
I am losing antifreeze in my 1996 Geo Metro 1L. Compression is 120/120/150. Would it be the head gasket or a cracked head to the exhaust? Thanks Al
What should compression be on a ezgo golf cart?
what should the compression be on a 2007 ezgo golf cart
What should compression be on a toro s200?
compression of a toro s200
Samsung metro 3310 forgot the password?
passward not working mobile traker
What should the cylinder compression compression test be on a 94 3000gt be?
It should be a high of 185 and a low of 140
What does it mean if a 1992 Geo Storm misfires badly after it is warmed up like it's firing on only two of the four cylinders?
It could be misfiring on two of the cylinders... Try a compression test first. If compression is low between two adjacent cylinders it might be a head gasket. If compression is up across all cylinders, it might be a coil-pack. The cylinders that AREN'T running should be obvious, since you should see that the sparkplugs are darker, fouled and/or soaked.
