0
What should you do if your kerosene flash is increasing in the column?
Wiki User
∙ 14y ago
By flash, it is assumed you mean the amount flashed in the flash zone after entering a column. If the amount flashed is more than you desire, lower the feed temperature. If the feed is some amount of saturated liquid and vapor, you will want to increase the percentage of liquid fed to the column. This applies to a general distillation column with more flash than desired.
If this is a crude oil atmospheric distillation column, and you are getting too much kerosene in a side draw, your cut point probably does not meet the required specification. In this case you will need to adjust your pumparound rates and/or increase the amount of reflux.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why need Over flash in distillation tower?
overflash acts as a reflux for the lowest tray from which side draw is made and the flash zone.It prevents heavier ends from reaching up the column.
Does the iPad 3 have a flash?
Flash as in camera? No. Flash as in Flash Player? No
When should I use flash or HTML or CSS to build a website?
That depends on a lot of things. Flash looks a lot nicer, has more possibilities, but can also drastically slow down your site. HTML and CSS can look nice too, with experience, and is faster too. But it doesn't have as many possibilities as Flash.
How can i clear flash player and java script error on you tube?
Any flash or JavaScript errors can be caused in a number of ways. Most of the time, it should be the website's fault if you receive a JavaScript or Flash Player error. Those will correct themselves over-time. But if you receive errors that you know nobody else (Or very few people) receive(s), then the problem could be on your end. Either your JavaScript, or flash player (or both), may be out of date and need to be upgraded. JavaScript can be updated by updating your browser. Flash Players can be updated by going to the Adobe website.
What is flash steam?
Flash steam is the condensation caused by reducing pressure.
What is the flashpoint of kerosene?
Kerosene is considered to be highly contestable. Kerosene has a flash point between one hundred and one hundred and sixty-two degrees Fahrenheit.
What is the flash point and autoignition temp of kerosene?
The flash point of kerosenes is between 35 0C and 65 0C. The autoignition point of kerosenes is 220 0C.
Does kerosene burn easily?
Yes. It has a low flash point, and a low ignition point.
At what temperature does paraffin ignite?
The flash point of kerosene is between 37 and 65 °C (100 and 150 °F)
Where is the blinker flash unit on a 1998 Mitsubishi eclipse located?
in the steering column.
What is the purpose of an alumina column?
Column chromatography is generally used as a purification technique: it isolates desired compounds from a mixture.Column chromatography is separated into two categories, depending on how the solvent flows down the column. If the solvent is allowed to flow down the column by gravity, or percolation, it is called gravity column chromatography. If the solvent is forced down the column by positive air pressure, it is called flash chromatography, a "state of the art" method currently used in organic chemistry research laboratories The term "flash chromatography" was coined by Professor W. Clark Still because it can be done in a "flash."
What is the difference between flash chromatography and column chromatography?
Column chromatography, is a broad term for all column chromatography methods, but is also synonomous with Gravity fed methods. Flash chromotography refers specifically to a column in which the eluant (or mobile phase) is moved through the column under pressure (using a hand pump for small scale, or a pressurised gas for a larger scale), the name Flash is derived from how much faster it is to run a column under pressure than via gravity.
What are the boiling points of petrol and kerosene?
-22f or -30c is the freezing point of kerosen
What would cause the headlights on a 1998 Mercury Mountaineer to go to high beam when you pull back on the lever to flash but not when you push it forward to stay on high?
there are two switchs in the steering column meaning pull back it hits a switch to flash and when you push it forward there is another to make them stay on. sounds like you need to replace the switch should be as simple as removing the steering column cover.
Can diesel or biodiesel be burned in a kerosene space heater?
ANSWER:Normal diesel fuel should not be burned in a kerosene heater, because there are many more contaminants in it, such as sulfur. A 100% solution of Biodiesel will not work because it requires a much higher initial temperature (300F) to burn cleanly. Blends of these fuels with kerosene can be burned, but there may be problems with the fuel soaking up the wick properly in the case of Biodiesel, which can lead to wick burning and sooting. There may also be problems lighting and burning properly if the blend contains too much of the Biodiesel, as its flash point is higher than kerosene. Diesel/Biodiesel fuel can also be run in many forced air heaters along with kerosene.
What is the flash point and fire point of diesl and kerosene?
flash point of petrol is > -45 degree celsius flash point of diesel is 52-95 degree celsius
Where can you buy flash drives for usb ports?
You can buy cheap flash drives in any department store or office store or even a supermarket. Flash drives are available everywhere these days due to the ever increasing technology.
