Dissolve it it water and filter it through paper. The sand will be in the paper and then sugar will be dissolved in the water. You can let the water evaporate and you will have the sugar back.
Use water. Mix it around, the sugar will dissolve into the water. Use a siv to separate the water and the sand, put the water in a container and wait for the water to evaporate: leaving sugar and sand.
to separate the mixture of sand and sugar:- first: you can mix water in it and after mixing you can separate the water and sand. and after that you boil the water until whole water is evaporated and you get sugar and sand separated. second: if difference b/w size of sugar and sand particle you can use met to separate them.
you pick out the stones, secondly you have to use filtering to pick out the sand and just leave the sugar.
Use a magnet to remove the iron, then pour what is left into water. The sugar should dissolve. pour the solution through a sieve to remove the sand and gravel. A fine sieve can be used to separate the gravel and sand.
Use a magnet to pick up the iron. Then add water. The sugar will dissolve and run out as syrup, and the sand will remain. ----
Firstly, water is to be added to make sugar water solution. The the total mixture of sand and sugar-water solution is passed through filter paper. The sand separates out and sugar water solution is collected in a vessel. Then by evaporating sugar is collected.
Yes!!!! Put the mixture in water. The Sugar will dissolve. The Sand will remain solid. Then filter. The sand will be trapped in the filter paper, and thr dissolved sugar will pass through the filter paper. The regain the sugar crystals., gently heat and evaporate the water of solution. and sugar crystals will reappear.
No. You should use evaporation of the water to separate the sugar and water.
l,
You could dissolve the bulk material in water, then pass the solution through a filter paper. This will stop all the sand. The residual solution should be evaporated under a reduced air pressure, so as to avoid overheating the sugar when it crystallizes out.
Remove the iron filings with a magnet. That will leave the sugar and sand left. Then use a fine sieve to remove the sand. Or if those particles are too much the same size, then add water to the mixture and then use a filter. The sand will stay behind on the filter. You now have to remove the water. You can do that by letting it evaporate.
use a strainer so the small grains of sugar and sand can escape then you will be left with the wood chips.