Want this question answered?
Yes.
They are the wires through which current flows when the circuit is closed.
Dear Wiki Questioner, When you disconnect a light bulb from a series circuit, the entire circuit is broken and no electricity can flow around it... so everything else on the circuit looses access to the power source! You can think of a series circuit as a relay race, where the runners are the bulbs and wires (and anything else that is connected to the circuit). If any one of the runners in a relay race is taken out of the race (say by a sprained ankle), the relay gets stuck and the team cannot complete the race (that is to say, the electricity cannot make a complete circuit). Of course, if you plug that runner back into the system, the race continues as usual!
SHORT CIRCUIT AND OVERLOADElectricity energy is supplied into homes by pairs of insulated copper wires placed on walls and ceilings.Not much heat is produced in the wires because copper has low resistivity.However,if the current is very large,the wires may become hot enough to melt or burn the insulation and start a fire.This large current may be caused either by a short circuit or by overloading the circuit. 2. CIRCUIT PROTECTORThe panel board in your home where electrical energy is distributed through different circuits contains fuses or has a circuit breaker system.Each circuit branching out from the panel is connected in series to a fuse or circuit breaker.Fuse and circuit breaker are safety devices that brake the circuit whenever overload or short occurs by breaking the circuit of fire are prevented.
Answer why does the person who made a circuit a probably connect the wires to a penny
The equipment is all connected in series with each other to make a complete electrical circuit.
When a switch is open (wires not connected) it is considered off. When a switch is closed it is considered on. If you move a switch and the wires are not connected the the circuit is open and current cannot run throughout the circuit to power the device.
If you are looking at a wiring schematic, junction refers to a point where two or more wires are connected together to complete a circuit.
The simplest circuit is a single loop of components connected in series; that is, the components are connected head to tail, with the first and last components connected to close the loop and complete the circuit. See the nearby link for the most rudimentary series circuit imaginable.
A circuit without any nonconducting wires
wires connected to a power source
The point where wires interconnect with other wires is known as a "junction". In your panel the circuit breakers are connected to the buss, each circuit breaker feeds a different circuit. Different circuits are not connected together.
It should be connected to circuit breaker. Circuit breaker will automatically discontinue the flow of electricity if it detects faulty condition.
a circuit is a round wire that connects through a battery into a lightbulb
Simple parts of a circuit are switches, light bulb, battery and connecting wires.
hardware parts are connected using buses,or wires in simple words
No, you can leave them in place as long as the circuit is dead and cannot be connected again.