Want this question answered?
It depends on size of wire and size of staple. a staple 1/2 inch long can hold 1 10-2 wire, 1 12-2 or 12-3 wire, or 2 14-2 or14-3 wires. basically the bigger the staple the more wires. Just be careful not to hammer the staple into the wire. You want the staple snug but not biting into the wire.
depends on the seats... but for some regular bucket seats, it shouldn't take more then three and a half yards of fabric for each of the driver and passenger seats. You'll probably want to pick up about 2 yards of some thin foam and a lining fabric, such as burlap, muslin, etc. for doing the pleating and padded parts of the seat. However, I'm yet to have to do a rear seat, so I can't help you there.
the size that fits...
Full size
No they don't. What actually happens is a hammer hits the staple from behind, the hammer is the same size as the staple to stop any distortion. The method by which the hammer is moved depends on the nature of the staple gun, if it is a manua gun then you squeezing the handle tensions a spring which then powers the hammer or in an electric or pneumatic gun the hammer is powered accordingly.
You can feed a yellow Lab Cichlid the Hikari Cichlid Staple pellets. A Cichlid that is 1.5 inches can feed off of the baby size pellets or the medium size pellets.
Most two seat sectional sleepers come with full size mattresses. Three seat sectionals come standard with queen size mattresses.
36"
usually the size is located on the tube where the seat post goes in
Pacman style frame seat diameter is 27.0 mm
Grade A
-7