0
What size are the steel brake line on a 1996 t-bird Are they metric as everything else is or SAE also the fittings metric or standard?
Wiki User
∙ 12y ago
The brake lines are 3/16", the fittings are metric a 131 mm wrench to get them off. These lines use a bubble flare, so pre-flared lines are the way to go. Also there are fittings available that switch from the metric bubble flare to the more familiar 45 double flare, if you just need to replace a section of the line.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can you use Teflon tape on brake line fittings and can you use standard tappered pipe fittings for hydrolic brakes with Teflon tape?
You do not need tape on any flared fitting, brake or regular. The brake line and the fittings are different size and thread type than regular copper line and fittings. You can't mix them.
Are the brake lines on a 1997 wrangler metric?
No, they're standard measurements
What size brake fittings 1997 Jeep Wrangler?
1/4 inch line, 3/8ths fittings.
What is the size of Suzuki Samurai brake line fittings?
3/16" line 10mm x 1.0 fittings double flare
How do you change a brake line on the brake booster?
The brake lines are not attached to the booster. They are attached to the master cylinder. To remove them, use an opened end wrench on the fittings located where the lines meet the master cylinder and slowly turn counter clockwise. BE CAREFUL NOT TO STRIP THE FITTINGS THEY ARE MADE OF BRASS AND ARE VERY SOFT!
1991 Plymouth acclaim brake line metric or sae?
They are SAE
Are ceramic brake pads the standard on a Mercedes-Benz?
No
Why do you hear air when you push your brake pedal?
Assuming you're in an air brake equipped vehicle, it could be a number of reasons. Loose air line fittings, ruptured air lines, or bad gaskets in one or more brake chambers would be the primary culprits.
2004 F250 Brake lights not working but everything else does?
replace brake light switch located on brake pedal under dash
How much is it approximetely to replace brake lines on a jeep wrangler?
To do it yourself, 30 or 40 bucks, for someone else to do it 2-3 hundred. Its all about the labor, brake lines and fittings are cheap, but that job takes time to do.
What size in the Allen wrench to loosen the front dic brake caliper bolts 9-32 or 7mm?
Much to my surprise, my Escape's (04) brake fasteners were all metric. I have both English and metric tools, used the English first cause it's a Ford and found they didn't fit. Went to metric and viola! I guess we can thank Mazda's influence for that.
How does the brake vacuum system work on a 1963 Chevy Impala If I push on the brake pedal I hear a hissing sound inside and the car stalls out?
If you have a power brake booster then there will be a vaccum line that runs to the brake booster on the firewall from the carburator. Check the booster for holes and broken fittings or buy a new booster. if no brake booster then brakes shouldn't affect vaccum
