0
What else can I help you with?
What causes 1993 Mazda MVP after changing battery terminals?
question makes no sense
RPM goes up on your Mazda MVP?
iac is bad need to be replace
How do you reset the computer on a Mazda MVP?
disconnect negative battery terminal depress brake petal fully for 30-45 seconds reconnect negative battery terminal
How do you replace a speed sensor on a Mazda mvp 2000?
To replace the speed sensor on a 2000 Mazda MVP, first, locate the sensor, typically found on the transmission. Disconnect the negative battery cable, then remove the electrical connector and the mounting bolt securing the sensor. Pull out the old sensor, install the new one, and secure it with the bolt. Finally, reconnect the electrical connector and the battery cable.
Is Mazda MVP engine a ford?
Yes
Mazda mvp heat will not work?
Well fix it!
Location of flasher on a 90 Mazda MVP?
The flasher on a 1990 Mazda MVP is located under the dash on the driver's side. It is just above and to the left of the brake pedal.
What is wrong when your 1993 Mazda MVP just clicks after you turn the ignition on?
sounds like your batteries dead, if you tried jumping it off with no luck, make sure the battery terminals are connected good
Where is cylinder 4 located on a 2004 Mazda 6 3.0?
what is the order of the cylinders on a 2003 Mazda MVP 3.0 v6
What type of engine oil for 2003 Mazda MVP?
5W-20 is recommended
Where is the fuel reset button on the Mazda mvp 1997?
There is no fuel pump inertia switch on any Mazda. These are found on Ford vehicles.
What would cause a 1996 Mazda MVP to stop running and not start again?
Check your ground wire from your neg battery to the pass side tranee. check for a breaks in wire. same for positive wire to starter and ignition. use a multi-meter.
