Want this question answered?
To answer this question the wattage of the heater is needed.
Did the breaker trip?
No! The minimum wire size allowable is 10 gauge for a 30 amp circuit. Don't risk the chance of an inner wall fire because too small of a wire gauge was used. Never shortcut anything to do with electrical wiring. Never.
it is used in a harbor where ships dock. breakers lower wave intensity so safe docking can be achieved. a breaker is no more than a big wall that runs underwater and above water.
no. the breaker is 40amps.fire hazard
To answer this question the wattage of the heater is needed.
The breaker you use is determined by the size of the wire in the wall not by what is being connected to that circuit. If you have 14/2 wire then use a 15 amp breaker. If you have 12/2 wire then use a 20 amp breaker. The breaker protects the wiring not the item connected.
The breaker you use is determined by the size of the wire in the wall not by what is being connected to that circuit. If you have 14/2 wire then use a 15 amp breaker. If you have 12/2 wire then use a 20 amp breaker. The breaker protects the wiring not the item connected.
You need to remove everything connected to the breaker and see if it still trips. If it does it is in the wiring or possibly a bad breaker. Disconnect load from breaker and see if it still trips. If so replace the breaker. If it still trips and is not the breaker then you will have to start pulling each outlet from wall and checking after disconnecting each outlet.
yes it is
You need to know how long each wall is as well as how tall the room is. Also, you have specified the door size. Are there no windows?You need to know how long each wall is as well as how tall the room is. Also, you have specified the door size. Are there no windows?You need to know how long each wall is as well as how tall the room is. Also, you have specified the door size. Are there no windows?You need to know how long each wall is as well as how tall the room is. Also, you have specified the door size. Are there no windows?
You need to turn off the power at the circuit breaker.
The well pump breaker is installed in two slots in your breaker box. You then run the correct size cable for the amperage of the pump to the area where the pressure tank is located. install a breaker or disconnect on the wall near the pressure tank and then connect the low pressure switch to the disconnect. Connect the pump to the low pressure switch.
The size of wall mount you need is around 50 inch wall mount or higher. For the sake of being sure, you may need to ask a professional for assistance on the subject. Good Luck on finding your answer.
The weight is 128 lbs and is to be wall mounted, you will need a hole in the wall that fits it.
Did the breaker trip?
Yes