0
It should use a 17mm (I think 11/16" will work, too) hex key. If you haven't got one of those, you can take one of the strut to control arm mounting bolts and back up the two nuts (one from each bolt) snug against each other on the bolt. Put the head of the bolt into the hex opening and to loosen it, turn the inside nut counter-clockwise. To tighten it later, just turn the outside nut clockwise.
What else can I help you with?
How do you remove wheel hub of a 2000 Nissan altima?
i front or rear.
How do you get at top rear strut mount on 97 dodge intrepid 3.5 es?
To access the top rear strut mount on a 1997 Dodge Intrepid 3.5 ES, first, lift the rear of the vehicle and securely support it on jack stands. Remove the rear seat and any trim panels to expose the strut mount access points. Then, unbolt the strut mount from above and detach the strut assembly from the lower control arm, allowing you to replace or service the strut mount as needed. Always consult a repair manual for specific torque specifications and safety precautions.
How do you replace rear shocks 2003 altima?
How do you replace rear shocks on a 2003 altima?
How do you access the stop light bulb on 2000 altima?
The stop light bulb is located in the rear window of the 2000 Altima. Hold the casing and pull it toward you to remove the casing and then you will be able to unplug the wiring and access the bulb.
How do you replace a rear shocks on a 2000 buick century?
Your vehicle is equipped with struts. Answer Provided By Freeautomechanic.com == To Remove: # Remove the three upper strut-to-body mounting nuts. # Raise and safely support the vehicle. # Remove the rear tire and wheel. # Disconnect the stabilizer bar link from the strut. # Scribe the strut to the knuckle so it can be installed in the original position. # Support the knuckle and hub and then remove the strut to knuckle bolts. # Remove the strut from the vehicle. To Install: Rear strut assembly removal/installation # Position the strut on the rear suspension. # Install the strut to knuckle bolts. Tighten the bolts to 90 lb ft (122 Nm). # Connect the stabilizer bar link to the strut. # Install the tire and wheel assembly. # Install the three upper strut mounting nuts. Tighten the nuts to 30 lb ft (41 Nm). # Lower the vehicle. # Check and adjust the rear wheel alignment if necessary.
Where can you find the fuel filter on a 2000 Honda Accord EX?
Under hood, driver side, rear side of strut tower, mounted in rear corner of engine compartment.
Where can you find the fuel filter for a 2000 Honda Accord SE?
UNDER HOOD, DRIVER SIDE, REAR SIDE OF STRUT TOWER, MOUNTED IN REAR CORNER OF ENGINE COMPARTMENT.
What is the rear leg room of the 2002 Nissan Altima?
The 2002 Nissan Altima has 36.4 in. of rear leg room.
What is the rear shoulder room of the 2013 Nissan Altima?
The 2013 Nissan Altima has 56.1 in. of rear shoulder room.
What is the rear shoulder room of the 2004 Nissan Altima?
The 2004 Nissan Altima has 56.1 in. of rear shoulder room.
What is the rear hip room of the 2012 Nissan Altima?
The 2012 Nissan Altima has 52.5 in. of rear hip room.
What is the rear hip room of the 2007 Nissan Altima?
The 2007 Nissan Altima has 52.5 in. of rear hip room.
