32 mm
5 x 100mm
2004 Subaru Impreza WRX Sportwagon.
not 100% on the stud pattern for the Toyota Avalon, but if ou can find that out, the subaru pattern is 5x100 if the Toyota has the same pattern it should be fine.
Yes. It will bolt right in, but before you swap it make sure the final drive ratio is compatible with the rear differential. Usually it will be either 3.9 or 4.11. You can swap the rear diff too if you have it.
im going to go out on a limb here and guess the 07 impreza bolt pattern is a 5 bolt star pattern
5x100
You will need to get one custom made, otherwise you can use any legacy/wrx body kit with enough modifications. Newer Legacy and Impreza body kits will not fit.
It is located on the top of the engine, below the throttle. Get a light and look straight down between the two throttle cables "if it has cruise control". It is bolted down with one 12mm bolt.
This is a Daewoo Lanos site I believe the same 1.6 Lt. engine is used by Subaru if this is true then the following will be correct. This is a three-step sequence and an “Angular Torque Gage is required. 25 Lb.-Ft + 70 degrees + 30 degrees.
5*100 is the bolt pattern
loosen axle bolt take outer tie rod bolt off remove from hub take bottom ball joint bolt off seprate from hub and pull out alittle and axle can come out then put it back together
NO! 2006 WRX STi bolt pattern = 5 x 114 2007 WRX bolt pattern = 5 x100 They will never fit. Sorry.