0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What would happen if you used a 60 amp fuse in a 6 amp circuit?
On a fault condition of the circuit, the current most likely will not be removed. If this happens components in the circuit will most likely act as a fuse and will components will be completely destroyed. This is why the manufacturer recommends what size of fuse to use in their equipment and this fuse size should always be used.
What amp size fuse should you use for your 99 new Beetle rear defogger if the fuse slot was empty when you bought the car used?
A 20 amp fuse should be safe to use.Did someone take it out because it blows fuses?? Mark
What size fuse for 12v battery?
The fuse you use is determined by the load on the circuit and the size wiring used in that circuit not the battery voltage.
Where is the horn fuse for caprice 1992 and what size should be used?
It's a 15 amp fuse. It is in the no 1 position on the fuse box. The fuse box is located on the drivers side; you can see it when you open the door its flush against the panel that has the steering wheel.
What size fuse is used for vw beetle 2008 12v receptacle?
It is a 20 amp fuse and located in position 27.
How fuse should be used in a 2.8kW kettle?
12a
What size fuse is used for the Ford Fusion brake lights?
The answer lies on the inside of the cover of the fuse box. There is a sticker that contains this information.
How does circuit breaker or fuse protect the house from fire?
The fuse is matched to the size wire in the circuit the breaker/fuse it is protecting. For instance, a 20 amp breaker/fuse is used in combination with AWG 12/2 wire. A 15 amp breaker/fuse would be used with AWG 14/2 wire. If there is too much current flow in the circuit caused by either overloading the circuit or by a short in the wires the wiring would overheat and catch fire if not for the breaker/fuse. The breaker/fuse is designed to detect this and to trip or blow and shut off all power flowing to that circuit and prevent a fire. This is why you should never install the wrong size fuse. Put a 20 amp fuse on a 15 amp circuit and it would not protect the circuit as it should.
What alternate fuse can I use to replace a 6.3 amp 125 volt slow blow fuse?
a 6.3 amp 125 volt fuse a 6.3 amp 250 volt or 300 volt is fine with similar time delays depending on application it may be easier to find a 10A it should still protect most of the components
What size fuse should be used for 2 amp power supply?
If the 2 amps is the output amperage of the power supply, the maximum that should be drawn from the unit is 2 amps. The load amperage that is connected to the power supply should govern the amperage of the fuse used. There is not much range there, the fusing could go from .25 to 2 amps. If the input amperage is 2 amps then the input and output voltage of the power supply should be stated.
Which size fuse should be used with a No 18 AWG extension cord where only two conductors are carrying current?
The protective device should be rated not more than 10 Amperes and be able to withstand a 1000Ampere short circuit.
Why does the primary side of a step down transformer burn out and not the secondary of a 480V to 240V transformer?
Sounds like the wrong size fuse protection was used. The transformer should be protected to its kva capacity.
