answersLogoWhite

0


Best Answer

36mm rear , 27mm front

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size of socket do you need for rear wheel nut of suzuki gsxr600 srad 98?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Need diagram for wheel assembly 1999 Suzuki Grand Vitara?

need diagram for wheel assembly 1999 suzuki vitara


What size spark plug socket do you need for a Suzuki gsx750f?

18mm Deep style socket.


What size socket do you need to take out spark plugs for a 1989 suzuki katana 600?

18m thinwalled socket


How do you replace front wheel bearings on a 1997 suzuki vitara?

You will need to remove the tire and wheel from your 1997 Suzuki. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.


Will 17'' inch alloy wheel with low profile tire fit the Suzuki swift model India?

A 17 inch alloy wheel with a low profile tire will not fit the Suzuki Swift model India, you will need a 15 inch wheel.


How do you replace left front wheel studs on my 2002 suzuki xl7?

Pound your 2002 Suzuki left front wheel studs out. You will need to pound in the new studs in the same manner that you removed the old studs.


What size socket do you need 4 wheel bearing on ford focus?

32mm for the axle nuts.


Do you have a fuse box diagram for a 1996 Suzuki cultus crescent?

need to diconect four wheel drive


Can you tow a Suzuki Samurai behind another vehicle?

Yes, but you need a two wheel car trailer.


What special wrenches do you need to change a rear wheel cylinder in a 99 Chevy Malibu?

Spline socket


What size socket do you need to change the wheel bearings on 1998 GMC Jimmy front and back axles?

Need to know if 2 wheel or 4 wheel drive for the front. Either way, there is no nut on the back axles.


How do you remove the flywheel key on a Suzuki 115 hp outboard motor?

Before you remove the flywheel key on a Suzuki 115 hp outboard motor you need to make sure you disconnect the sparkplugs and remove the flywheel nut. Then, you will need a tool to keep the wheel stationary as well as a lobe wheel peeler.