Wire is sized by the load amperage. The formula for amperage when the HP is known is I = HP x 746/1.73 x E X %eff x pf.
A standard motor's efficiency between 5 to 100 HP is .84 to .91.
A standard motor's power factor between 10 to 100 HP is .86 to .92.
I = 60 x 746 = 44760/ 1.73 x 480 x .89 x .89 = 44760/658 = 68 amps.
Motor feeders have to be sized to 125% of the motors full load amps. 68 x 125% = 85 amps
A #3 copper conductor will limit the voltage drop to3% or less when supplying 85 amps for 220 feet on a 480 volt system.
i have 200 hp motor what i need cable size in 100 feet distance
12 AWG in most circumstances.
Assuming you are working with 240v, you need 4/0 copper conductors.
In the US and Canada, 10 Guage wire will suffice
No, the voltage difference is too much. A 570 volt motor falls in the 600 volt range which is separate from the 480 volt range of three phase systems.
i have 200 hp motor what i need cable size in 100 feet distance
4.5 volt battery sold only in Russo
The motor would take 10-12 amps which would need wire of 1.5 mm2 or larger. For a permanent installation use the next size, 2.5 mm2 cross section.
110v 40 uf
A 3/0 copper conductor will limit the voltage drop to 3% or less when supplying 200 amps for 200 feet on a 240 volt system.
12 AWG in most circumstances.
You can but the motor may not run, however you will not burn the motor.
Yes this size motor can be operated by bringing a 600 volt three phase supply to it.
NO
sucka dick?
Assuming you are working with 240v, you need 4/0 copper conductors.
No, the voltage difference is too much. A 570 volt motor falls in the 600 volt range which is separate from the 480 volt range of three phase systems.