0
Blade type mounted on a dovetail cut in the barrel
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you affix front rifle sight?
You need a gunsmith.
How do you use the front site on a Remington 03A3 rifle?
line up the target on the top of the front sight while sighting the front sight through the rear peep sight.
What is sight a llinment on a rifle?
Aligning front and rear sites to aim
How do you remove front sight blade on Remington 742 rifle?
1. Remove the screw to the rear of the front sight ramp.2. Remove the "blade" from the front sight ramp.3. Remove the screw from the front of the front sight ramp (which was formerly seated under the "blade").
What two parts of the rifle do have to align to hit the center of the target?
The front and rear sight
What kind of value could you get from a model 68-22 rifle in good condition?
Condition is everything. If you have the original aperture sight, the hooded front sight, and in least 95% or better condition, we've seen them sell recently for $450 and up. sales@countrygunsmith.net
Who supplys front sight for a Stevens 22 rifle befors serial numbers were required?
Savage firearms bought Stevens in 1920. Brownells can also supply a generic front sight.
How do you read sight for springfield 1903 rifle?
Start by reading the manual on the rifle. The link below will take you to an on-line copy of the original military manual.
Would the front sight hood be compatible with the G98.40 Mauser?
Would the front sight hood for what be compatible with a G98/40, which by the way, is not a Mauser. The standard K98 sight hood will fit on a G98/40 rifle, but it will not sit well and would not be correct. The 98/40 used a proprietary sight hood that no other rifle in the world used. They are exceptionally rare today.
What part of the rifle do you look at to hit the center of the target?
You are looking for the "sight picture". that is formed when you align the rear sight with the front sight and the target. Here is how to find it. At the very end of the barrel on top is the front sight. About 2/3 of the way back and still on top is the rear sight. If you hold the rifle stock to your shoulder and support the front of the weapon with one hand you can look down the barrel. You will notice the rear sight looks something like a V and the front sight will look like a dot. If you move the rifle so that the dot appears to be in the middle of that V you have accomplished your initial "sight picture". Now keeping the dot in the center of the V align that with the target you wish to hit. This is your complete sight picture. It will take practice to figure out if the wind is affecting you and distance to the target and a lot of other things but that is the correct way to sight the rifle in and should get you started. Good luck.
Where can you locate front sight blade for JC Higgins model 50 rifle?
Try e-gunparts.com
How do you set rifle sites on barrel?
The rear sight must move in the direction you want the point of impact to move. The front sight can be moved in the opposite direction.
