any 8 inch
want to replace fuel gauge with aftermarket gauge, need to keep stock sending unit, will a 230 ohm gauge work
stock keeping unit
The entire solenoid group must be replaced .It is one unit.
No difference. A unit of stock is called a share.
This is only going to answer 1/2 of your question but the oil pressure sending unit is on the drivers side of the engine , below the power steering pump
any radio can have a sub you just need a amp to power it.
with a head Unit DRIVERRR
balboa
had to replace mine on my 96 explorer ,it will start for a second then stop,rough idling,thought it was my timiing replaced it now it runs great. ----------------- Check the fuel pressure also.
The ABS Sensor is located inside of the hub, which is replacable only by replacing the entire hub assembly as a unit.
the fuel pump and filter are located in the fuel tank and are all one unit with the fuel guage it is replace as a unit and should be replaced with the stock factory Chrysler pump as they have been upgraded
My 2004 ford explorer there isn't any vacum from the present heater control valve and the blower has been replace and the themostat has been replace and there is a clicking behind the a/c unit